How-to Instructions

Replacing worn out stiletto shoe heel tips

Choose your stiletto heel replacement tips - 15 sizes available from 8mm to 20mm

• Materials: stiletto heel tips suits • epoxy glue
  
• Tools: pliers • hammer
  

1. Use pliers to firmly pull out to remove worn out heel tips, rotating to loosen if necessary.
2. Place the new heel tip by inserting into the hole with a hammer until it fits with no gap in sight
3. If the hole is bigger than the pin, apply some silicon or super glue on the pin before inserting into the hole, this will ensure strengthen the hold.

Replacing worn out shoe & boots under shoe sole

• Materials: Replacement shoe rubber sole, epoxy glue, rags, shoe repair nails
  
• Tools: pencil marker, filing tool or rough sandpaper, hammer

• Clean and wipe the bottom of shoe and ensure there is no dirt, mud, grease or any debris, and ensure the shoes are dry before beginning the replacement process
• Determined the right cow muscle shoe sole to affix
• Trace the cow muscle shoe sole to be positioned where fitting (either side) with the pencil marker
• Once the position has been marked, apply the glue on the rubber sole (smooth side) and also the shoe sole bottom to be affixed
• Let the adhesive glue set for several minutes (as per directions on the manufacturer's label)
• Carefully position before adhering the sole onto the shoe bottom, press them correctly into position; they can't be moved once they are in position
• Press hard ensuring both surfaces adhere; lightly hammer the bottom of the replaced sole if needed
• Let the glue dry and fasten for a few hours, you can put on the shoes and walk around for several minutes to ensure they are adhesively cemented